Richard Akit Engineer Commercial and Industrial Boiler

Richard Akit Engineer Commercial and Industrial Boiler

  • Hamilton EVO Submittal

    D. 0-10 VDC - connect a 0-10 VDC output here to vary set point temperature. E. Additional Heat Source - dry contacts that will close a thermostat on an extra boiler if the cascade system is at of capacity. F. Lock Out Signal - alarm bell or light mayGet Price

  • Streamline FS 150 & 225

    Streamline FS 150 & 225 Packaged Modular Boiler Systems incorporating Two or Three 75kW Low NOx Premix Gas Fired Condensing Modules in each Cabinet. Power, efficiency, reliability and turndown With up to 15 to 1 turndown ratio, and completely factoryGet Price

  • SECTION 230900 - INSTRUMENTATION AND CONTROLS FOR HVAC

    The lead and lag boilers shall be cycled to divide time evenly between the boilers. Packaged boiler controls shall control the boiler to maintain the HWS temperature setpoint. A system HWS temperature sensor shall signal the DDC controller, which shall reset the HWS temperature linearly from 180ºF at 30ºF outside air to 140ºF at 65ºF outside air (adjustable).Get Price

  • Combustion Source Inspection: Student Reference Manual

    Turndown Ratio A measure of the practical range over which a burner will operate is called the "turndown ratio.' It is defined as the maximum practical firing rate divided by the minimum practical firing rate. This ratio is very important because boilers are usuallyGet Price

Hot News

Hot News

Hot News